Pumping stations for wells: the subtleties of choice
Owners of private houses that do not havecentralized water supply system, they need to solve the problems related to water supply independently. If a plot or garden can be completely watered from a natural reservoir or well, using an ordinary pump for this, then such a system is completely inappropriate for housing. With this task, only the connection of the pumping station to the well will help. It is so powerful that the resource is enough for watering the garden, trees, water filling capacity, as well as uninterrupted water supply to the dwelling.
To determine which pumping stations forwells are right for you, you need to understand their main parts, that is, to find out their composition, as well as moments that are important to take into account with special attention. The presence of a non-return valve is first of all determined. With the help of it, it is possible to significantly extend the life of the station, increase the safety of the service, since it provides protection against idling, when the supply of water for some reason ceases. Another important point is the presence of an input filter, which provides protection to the pump station itself, as well as a check valve against all kinds of contamination. The filter can be removed easily if necessary to clean.
Pumping stations for wells should be equipped withtanks, in one part of which there is liquid, and in the second air under pressure. This allows the device to work for a certain time after stopping the supply of electricity. The tank in this case acts as a battery. Water is supplied by the pressure of the air inside it, the check valve does not allow the water to move back, so it only remains to move it to the water pipe.
Due to the presence of a tank, pumping stations forwells receive a number of advantages. Depending on the size, it always has 25-50 liters of water, which can be used for household needs, if electricity is turned off. There is no need to install a storage tank in the attic. The water system receives the required pressure to supply water to the bathroom, the kitchen or the bathroom. Pumping stations for wells serve much longer due to a reduction in the number of on-offs.
The principle of operation of this type of equipment is veryis simple and reduces to the following. At the initial stage, the water is pumped into the tank. When it is fully filled, the unit goes into standby mode, and it lasts until a certain pressure level is reached in the second part of the tank. Now you can open taps in the house to use water. The pump station switches on automatically as soon as there is a pressure drop inside the tank. And so it will happen as many times as it is required. Automation clearly monitors the level of pressure. If the unit overheats, it turns off, and after the normalization of its state is switched on again. The cooler in this case is water, which is pumped. Installation of the pumping station in the well allows solving a number of problems of providing the dwelling with water.